Moxa Technologies EtherDevice Manuel d'utilisateur télécharger pdf (Page 64)

EDS-508 Series User’s Manual Featured Functions

3-48

2. Configuring Email Settings

To configure EDS’s email setup from the Console interface or browser interface, enter your

Mail Server IP/Name (IP address or name), Account Name, Account Password, Retype New

Password, and the email address(es) to which warning messages will be sent.

3. Activate your settings and test email if necessary

After configuring and activating your MOXA EtherDevice Switch’s Event Types and Email

Setup, you can use the Test Email function to see if your e-mail addresses and mail server

address have been properly configured.

Email Alarm Events Settings

Event Types

Event Types can be divided into two basic groups: System Events and Port Events. System

Events are related to the overall function of the Switch, whereas Port Events are related to the

activity of a specific port.

System Event Warning e-mail is sent when…

Switch Cold Start Power is cut off and then reconnected.

Switch Warm Start EDS is rebooted, such as when network parameters

are changed (IP address, netmask, etc.).

Power Transition (On"Off) EDS is powered down.

Power Transition (Off"On) EDS is powered up.

DI1 (On"Off) Digital Input 1 is triggered by on to off transition

DI1 (Off"On) Digital Input 1 is triggered by off to on transition

DI2 (On"Off) Digital Input 2 is triggered by on to off transition

DI2 (Off"On) Digital Input 2 is triggered by off to on transition

Configuration Change Activated Any configuration item is changed.

Comm. Redundancy Topology

Changed

If any Spanning Tree Protocol switches have

changed their position (applies only to the root of the

tree).

If Master of Turbo Ring has changed or backup path

is activated.

Authentication Failure An incorrect password is entered.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 91 92

Pas de commentaire

Moxa Technologies EtherDevice Manuel d'utilisateur Page 64