Moxa Technologies EtherDevice Manuel d'utilisateur télécharger pdf (Page 37)

EDS-508 Series User’s Manual Featured Functions

3-21

Configuring Turbo Ring

The following figures indicate which Turbo Ring Protocol parameters can be configured. A more

detailed explanation of each parameter is given below the figure.

Now Active:

This field shows which communication protocol is on used: Turbo Ring, RSTP, or neither.

Master/Slave:

This field appears only when selected to operate in Turbo Ring mode. It indicates if this EDS is or

is not the Master of the Turbo Ring.

NOTE

The user does not need to set the master to use Turbo Ring, only to assign which segment

serves as the backup path.

The master will be determined automatically if the user does not set a dedicated master for the

Turbo Ring.

Redundant Port Status

This field indicates the current status of redundant ports. The state is “Forwarding” for normal

transmission, “Blocked” to stop transmission if this port is the backup path, and “Link down” for

non-connection.

Ring Coupling

Indicates if the Ring Coupling function is “Enabled” or “Disabled.”

Coupling Port Status

This field indicates the current status of coupling ports. The state is “Forwarding” for normal

transmission, “Blocked” to stop transmission if this port is the backup path, and “Link down” for

non-connection.

At the bottom of the page, the user can configure this function’s “Settings.” For Turbo Ring, the

user can configure:

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 91 92

Pas de commentaire

Moxa Technologies EtherDevice Manuel d'utilisateur Page 37