Moxa Technologies EtherDevice Manuel d'utilisateur télécharger pdf (Page 29)

Wiring MOXA EtherDevice Server

MOXA EtherDevice Server User’s Manual

3-5

Wiring the Redundant Power Inputs

MOXA EtherDevice Server has two DC inputs located on the top panel. Top and front

views of one of the terminal block connectors used to connect to a DC power source are

shown here. Note that when viewed from this angle, the negative DC wire goes in the

terminal block connector’s left terminal, and the positive DC wire goes in the right

terminal.

STEP 1: Insert the negative/positive DC wires into the left/right

terminals (1) on the top of the terminal block connector.

STEP 2: To keep the DC wires from pulling loose, use a small

flat-blade screwdriver to tighten the wire-clamp screws (3) on the

front of the terminal block connector.

STEP 3: Insert the plastic terminal block connector prongs (4) into

the terminal block receptor, which is permanently fixed to MOXA

EtherDevice Server’s top panel.

STEP 4: Use a small flat-blade screwdriver to tighten the two screws

(2) on the top of the terminal block connector to fix it to the terminal

block receptor.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 121 122

Pas de commentaire

Moxa Technologies EtherDevice Manuel d'utilisateur Page 29