Moxa Technologies EtherDevice Guide d'installation

Moxa EtherDevice Switch EDS-305/308 Hardware Installation Guide Ninth Edition, June 2008 © 2008 Moxa Inc., all rights reser

- 10 - ATTENTION Before connecting the EDS to the DC power inputs, make sure the DC power source voltage is stable. Communication Connections EDS-3

- 11 -100BaseFX Ethernet Port Connection The concept behind the SC/ST port and cable is quite straightforward. Suppose you are connecting devices I

- 12 -one of the ports for which the corresponding PORT ALARM DIP Switch is set to ON is not properly connected. If neither of these two conditions

- 13 -Auto MDI/MDI-X Connection The Auto MDI/MDI-X function allows users to connect the EDS’s 10/100BaseTX ports to any kind of Ethernet device, wit

- 14 -The EDS operates in the store-and-forward switching mode, which eliminates bad packets and enables peak performance to be achieved when there

- 15 -Min. TX Output, dBm -20 -15 -5 -5 Max. TX Output, dBm -14 -6 0 0 Sensitivity, dBm -34 to -30 -36 to -32 -36 to -32 -36 to -32Recomme

- 16 - Technical Support Contact Information www.moxa.com/support Moxa Americas: Toll-free: 1-888-669-2872 Tel: +1-714-528-6777

- 2 -Overview Moxa’s EtherDevice™ EDS-305 and EDS-308 are smart Ethernet switches that provide an economical solution for your Ethernet connections.

- 3 -Panel Layout EDS-305Front Panel View5678910112EDS-308Front Panel View811 V1 V2 INPUTS: 24 VDCPWR2V2+V2-V1-V1+12345ON DIPPORT ALARMFAUL

- 4 -Panel Layout (SC-type) EDS-305-M-SCFront Panel View1213EDS-308-MM-SCFront Panel View12EDS-308-M-SCFront Panel View1213567891011213567 V1 V2 INP

- 5 -Panel Layout (ST-type) EDS-308-MM-STFront Panel ViewEDS-305-M-STFront Panel View121356712135679101128 V1 V2 INPUTS: 24 VDCPWR2V2+V2-V1-V1+12345

- 6 -Mounting Dimensions (unit = mm) Rear ViewSide View Front ViewDlN-Rail Kit DlN-Rail Kit DlN-Rail 105.009.0019.8035.0030.00135.0013.10 25.4015.10

- 7 -Wall Mounting (optional) For some applications, you will find it convenient to mount the EDS on the wall, as illustrated below. STEP 1: Remove

- 8 -Wiring Requirements WARNING Do not disconnect modules or wires unless the power supply has been switched off or the area is known to be non-ha

- 9 -Grounding the EtherDevice Switch Grounding and wire routing help limit the effects of noise due to electromagnetic interference (EMI). Run the