Moxa Technologies 6110 Manuel télécharger pdf (Page 27)

TC-6110 Hardware Hardware Installation

2-17

Step 9: Use a small screwdriver or other tool to release the clutches on the battery socket, and remove the old

battery. Gently place the new battery into the socket.

Step 10: When finished, reverse the steps above to rebuild the TC-6110 unit.

Installing System Memory and CF Card

The TC-6110 computer comes with two system memory sockets; one of these is pre-installed with 2 GB of

memory. In addition, an 8 GB CompactFlash card has also been pre-installed. Follow the steps below to add or

replace either the system memory or the CF card.

Refer to Steps 1 through 8 in the section, Replacing the Battery; then follow the steps below.

Step 9: Remove the seven brass standoffs on

the upper main board.

Step 10: Gently remove the upper main board,

and then locate the system memory and CF

socket.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 44 45

Pas de commentaire

Moxa Technologies 6110 Manuel Page 27