Moxa Technologies DA-710 Series Manuel d'utilisateur télécharger pdf (Page 30)

DA-710 Series HW User’s Manual Hardware Installation

LED Color Description

Green 100 Mbps Ethernet mode

Orange 1000 Mbps (Gigabit) Ethernet mode

Gigabit RJ45

Connector

Off Not operating or 10 Mbps Ethernet mode

The default IP addresses and netmasks of the Gigabit LAN ports are as follows:

Default IP Address Netmask

LAN 1 192.168.3.127 255.255.255.0

LAN 2 192.168.4.127 255.255.255.0

LAN 3 192.168.5.127 255.255.255.0

LAN 4 192.168.6.127 255.255.255.0

Upgrading the Memory Module

The DA-710 embedded computer supports one 200-pin DDR2 533 SODIMM module, of up to 2

GB. A 1-GB DDR2 SDRAM memory module is factory-installed. To upgrade the DDR2 SDRAM

memory module, follow these instructions:

1. Disconnect the DA-710 from the power source. Make sure all the expansion modules have

been removed.

2. The DA-710’s memory module is located inside the DA-710, just below the expansion

modules. Unscrew the top cover of the DA-710.

2-17

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 55 56

Pas de commentaire

Moxa Technologies DA-710 Series Manuel d'utilisateur Page 30