Moxa Technologies UC-7112 LX Plus Manuel d'utilisateur télécharger pdf (Page 12)

UC-7112-LX Plus Software User’s Manual Getting Started

2-4

Use a straight-through Ethernet cable to connect to a hub or switch that is connected to your local

LAN. The default IP addresses and netmasks are shown above. To log in, type the Login name and

password as requested. The default values are both root:

Password: root

You can proceed with configuring the network settings of the target computer when you reach the

bash command shell. Configuration instructions are given in the next section.

ATTENTION

Serial Console Reminder

Remember to choose VT100 as the terminal type. Use the cable CBL-4PINDB9F-100, which

comes with the UC-7112-LX Plus, to connect to the serial console port.

Telnet Reminder

When connecting to the UC-7112-LX Plus over a LAN, you must configure your PC’s Ethernet

IP address to be on the same subnet as the UC-7112-LX Plus that you wish to contact. If you do

not get connected on the first try, re-check the serial and IP settings, and then unplug and re-plug

the power cord.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 81 82

Pas de commentaire

Moxa Technologies UC-7112 LX Plus Manuel d'utilisateur Page 12