Moxa Technologies Switch EDS-726 Manuel d'utilisateur télécharger pdf (Page 76)

EDS-726 Series User’s Manual Featured Functions

3-61

Using Line-Swap-Fast-Recovery

The Line-Swap Fast Recovery function, which is enabled by default, allows EDS-726 to return to

normal operation extremely quickly after devices are unplugged and then re-plugged into different

ports. The recovery time is on the order of a few milliseconds (compare this with standard

commercial switches for which the recovery time could be on the order of several minutes). To

disable the Line-Swap Fast Recovery function, or to re-enable the function after it has already

been disabled, access either the Console utility’s Line-Swap recovery page, or the Web Browser

interface’s Line-Swap fast recovery page, as shown below.

Configuring Line-Swap Fast Recovery

Enable Line-Swap-Fast-Recovery

Setting Description Factory Default

Enable/Disable Check-mark the check box to enable the

Line-Swap-Fast-Recovery function

Enable

Using Set Device IP

To reduce the effort required to set up IP addresses, the EDS-726 series comes equipped with

DHCP/BootP server and RARP protocol to set up IP addresses of Ethernet-enabled devices

automatically.

When enabled, the Set device IP function allows EDS-726 to assign specific IP addresses

automatically to connected devices that are equipped with DHCP Client or RARP protocol. In

effect, EDS-726 acts as a DHCP server by assigning a connected device with a specific IP address

stored in its internal memory. Each time the connected device is switched on or rebooted,

EDS-726 sends the device the desired IP address.

Take the following steps to use the Set device IP function:

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 100 101

Pas de commentaire

Moxa Technologies Switch EDS-726 Manuel d'utilisateur Page 76