Moxa Technologies EtherDevice Guide d'installation télécharger pdf (Page 7)

- 7 -

Wiring the Power Inputs

The two left-most contacts of the 3-contact terminal block connector on the

EDS’s top panel are used for the DC and AC inputs. Top and front views of

one of the terminal block connectors are shown here.

STEP 1: Insert the negative/positive DC wires

into the V-/V+ terminals.

STEP 2: To keep the DC wires from pulling

loose, use a small flat-

lade screwdriver to tighten

the wire-clamp screws on the front of the terminal

block connector.

STEP 3: Insert the plastic terminal block

connector prongs into the terminal block receptor,

which is located on the EDS’s top panel.

y Only connect to a class 2 power supply.

y Only use 60/75°C copper (CU) wire, 28-12 AWG.

y Use a maximum torque of 4.5 in-lb.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Moxa Technologies EtherDevice Guide d'installation Page 7