Moxa Technologies ETHERDEVICE EDS-305 Guide d'installation télécharger pdf (Page 15)

— 14 —

Grounding the SPL-24

Grounding and wire routing help limit the effects of

noise due to electromagnetic interference (EMI). Run

the right most contact of the 3-contact terminal block to

the grounding surface prior to connecting devices.

ATTENTION

This product is intended to be mounted to a well-grounded

mounting surface, such as a metal panel.

Wiring the SPL-24’s Power Outputs

The two left-most contacts of the 3-contact terminal block connector on the

SPL-24’s top panel are used for 24 VDC output. Top and front views of one of

the terminal block connectors are shown here.

STEP 1:

Insert the negative/positive DC wires into the V-/V+

terminals.

STEP 2:

To keep the DC wires from pulling loose, use a small

flat-blade screwdriver to tighten the wire-clamp screws

on the front of the terminal block connector.

STEP 3:

Insert the plastic terminal block connector prongs into

the terminal block receptor, which is located on

SPL-24's top panel.

1 2 ... 10 11 12 13 14 15 16

Pas de commentaire

Moxa Technologies ETHERDEVICE EDS-305 Guide d'installation Page 15