Moxa-technologies C168P Manuel d'utilisateur télécharger pdf (Page 32)

3-10 C168P User’s Manual

Installing Driver

Up to four C168P boards can be installed together as long as the I/O addresses and

IRQ number resources are sufficient and available in a system.

The following is the procedure for installing C168P

for the first time under

Windows 95/98:

1. Run Setup95.exe in the driver diskette.

2. Click on [Next>] button in the “Welcome ...” message dialog box. And then

click on [

Next>] button in the “Ready ...” message dialog.

3. Click on [Finish] button in the “Complete ...” message dialog to enter the

configuration panel.

4. The “Moxa Smartio/Industio Configuration Panel” dialog will pop up for you

to configure the boards and ports.

5. In the “Moxa Smartio/Industio Configuration Panel” dialog box, click [Add]

to enter “

Property” dialog box to add the C168P board. Select the “C168

Series”

in the “Board Type” field. If necessary, type the desired interrupt vector

address, in the “INT Vector” field. Select the desired interrupt number in the

“Interrupt No.” field. Type the desired base I/O address, in the “Base I/O Port

Address” field. All the settings should match settings that are physically set on

the board and conflict with no other devices.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 79 80

Pas de commentaire

Moxa-technologies C168P Manuel d'utilisateur Page 32