Moxa Technologies SMG-6100 Manuel d'utilisateur télécharger pdf (Page 36)

SMG-1100/6100 SMG Manager

3-22

The Serial tab is where each serial port’s communication parameters are configured. You can configure Baud

Rate, Parity, Stop Bit, Flow Control, FIFO, and Interface Mode. Data bits is not configurable.

The Slave ID Map tab is where slave IDs are managed. The definitions on this tab determine how requests will

be routed by the unit.

When the serial port is set to RTU Master or ASCII Master mode, simple select the Slave ID entry in the table

and modify the range. For TCP slaves, you can add an entry that assigns a range of IDs to a specific IP address,

using the Remote TCP Slave settings including TCP Port.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43

Pas de commentaire

Moxa Technologies SMG-6100 Manuel d'utilisateur Page 36