Moxa Video Encoder VPort 251 Series Quick Installation Guide Second Edition, June 2008 © 2008 Moxa Inc., all rights reser
DIN-Rail Mounting (Optional) The VPort 251 can be mounted on a 35-mm DIN-rail using the DK-35A accessory (ordered separately). Wall Mounting Th
You should also pay attention to the following: y Use separate paths to route wiring for power and devices. If power wiring and device wiring paths
STEP 1: Insert the negative (ground)/positive DI wires into the ┴/I1 terminals. STEP 2: To keep the DI wires from pulling loose, use a small flathea
RJ45 (10-pin) to DB25 (F) Cable Wiring RJ45 Plug Pin 1DCDDSRRTSGNDTxDRxDCTSDTRDCDDTRCTSGNDRxDTxDRTSDSR1234/75689864723520 10/100BaseT(X) Ethernet Por
PTZ Port A PTZ port is located on the VPort 251’s bottom panel. The port is used to connect to a PTZ motorized camera or device, so that the camera o
- 15 -Specifications Video Video Compression MPEG4, MJPEG Video Input 1, BNC connector NTSC/PAL Auto-sensing or manual Video Resolution and FPS
- 16 -EMS EN61000-4-2 (ESD), Level 2 EN61000-4-3 (RS), Level 3 EN61000-4-4 (EFT), Level 3 EN61000-4-5 (Surge), Level 3 EN61000-4-6 (CS), Le
- 2 -Overview The VPort 251 is a high performance, 1-channel video encoder in a compact form factor that is suitable for installation in a variety o
- 3 -y 1 auto-sensing 10/100BaseT(X) Ethernet port y RS-232/RS-422/RS-485 COM port for controlling PTZ (pan/tilt/zoom) motorized cameras y &qu
VPort 251 Panel Layout 2511-Channel Video EncoderTCP,UDP,HTTP,DHCP,SMTP,FT P,N TP, DN S, RT SP, IG MP,QoS,DDNS,SNMPPTZRS-232 or RS-422/485POWER1x pow
- 5 -Initial Installation and Configuration Before installing the VPort 251, verify that all items in the package checklist are present. In addition
NOTE Drivers are required to support specific PTZ control protocols. The VPort 251 supports the following protocols: y Pelco D y Pelco P y DynaC
3. When the search is complete, every EDS switch and VPort found on the network will be listed onscreen. NOTE Broadcast Search can only search fo
NOTE For Windows XP SP2 or above, the ActiveX Control component may be automatically blocked for security reasons. In this case, the warning message
For details on each item, please refer to the User’s Manual. NOTE Administrators should go to System Configuration Æ System Æ Account in the VPort’
Commentaires sur ces manuels