Moxa Technologies NPort 5200 Serie Guide d'installation télécharger pdf (Page 15)

Getting Started

3-5

Assigned (IP assigned status), Model, and Auto IP (indicates whether

or not this VPort has an auto IP assigned function) of the VPort will be

listed in the VPort Installation Wizard window.

4. Select the VPort by checking the box in front of the MAC address.

5. Click the “Link to selected device” button to open the VPort’s web

console via Internet Explorer.

Note

The IP assigned status will be listed as Yes if the VPort has been

assigned an IP address. If it is No, please check if there is a

problem with the DHCP network environment, or if the model you

are using does not support the auto IP assigned function.

In a Non-DHCP Server Networking Environment

If your VPort is connected to a network that does not have a DHCP server,

then you will need to configure the IP address manually. There are two

ways to access the server:

1. If one VPort is connected to the network, open your web browser and

type the default IP address in the browser’s address box. In this case,

the default IP address is 192.168.0.99 and the default subnet mask is

255.255.255.0. Note that you may need to change your computer’s IP

address and subnet mask so that the computer is on the same subnet as

the VPort.

2. If two or more VPorts are connected to the network, the default IP

addresses are 192.168.0.99, 192.168.0.100, etc. In this case, you can

use the MOXA VPort Installation Wizard utility to determine the

location of each VPort connected to the network. Since the VPort

Installation Wizard searches by MAC address, the VPort and computer

must be connected to the same Ethernet LAN for the VPort Installation

Wizard to locate the VPort.

Note

VPort’s Network and Status LEDs can be used to determine if the

VPort is transmitting and receiving data over the network. Refer to

the User’s Manual to see how to interpret the Network and Status

LEDs.

Assigning the IP Address Manually

To change the IP address of the VPort manually, access the VPort’s web

server, and then navigate to the Configuration\ Network page to configure

the IP address and other network settings. Uncheck the “Reset IP address at

next boot” checkbox to ensure that the IP address you assign is not deleted

each time the VPort is restarted.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Moxa Technologies NPort 5200 Serie Guide d'installation Page 15